Huntron ® Tracker ® 3200S - PT. Sumber Instrumindo

Huntron ® Tracker ® 3200S

3200S

Huntron

The Huntron Tracker 3200S is designed to encompass our product history and leadership in power-off test by providing powerful test and troubleshooting solutions. The Tracker 3200S features variable range parameters resulting in hundreds of voltage, source resistance and frequency combinations. You can create Tracker ranges to precisely fit your needs. The Tracker 3200S uses a color, touch screen LCD for control of features such as range configuration, front panel pin selection and Channel A/B settings. The Tracker 3200S LCD provides a very fast screen refresh rate for quick screening of component pins and display the A and B channel signatures at the same time (A+B mode). The built-in Pulse Generator enables you to dynamically test gated devices such as SCRs, TRIACs and relays (see Quicktip #14 on the Technical Support web page for more about using the Pulse Generator).

Features

Key capabilities and advantages

Add the benefits of Power-Off test to your current diagnostic test strategy
Can be used as a Stand-alone unit using the convenient front panel controls and touch screen LCD
Match the circuit impedance by setting the applied voltage, frequency and source resistance
Built-in Pulse Generator for testing gated devices such as relays, SCRs and TRIACs
128 pin scanning with 128 Commons using the built-in front panel IDC ribbon cable connectors
Display A or B channels individually, in the switching ALT mode or in A+B mode to display both signatures at the same time
Connect to a Huntron Access 2 Prober for full test automation
Having the Good board signatures stored on your PC eliminates the need to keep one for direct comparison
A software based test allows for the sharing of board test knowledge with all personnel
Use the Huntron Workstation software to create circuit board tests, store analog (V-I) signatures, make good vs. bad comparisons and present the results

Specifications

Technical specifications and parameters

Part Number	99-0432
Number of Voltages plus values	24 voltages : 200mV, 400mV, 600mV, 800mV, 1V to 20V in 1V steps including 10V (Low), 15V (Med 1), 20V (Med 2)
Number of Resistances plus values	16 resistances : 10Ω, 20Ω, 50Ω, 100Ω, 200Ω, 500Ω, 1kΩ, 2kΩ, 5kΩ, 10kΩ, 20kΩ, 50kΩ, 100kΩ, 54Ω (Low), 1.2kΩ (Med 1), 26.7kΩ (Med 2)* * Through Huntron Workstation only
Number of Frequencies plus values	40 frequencies : 20Hz to 190Hz in 10Hz steps; 200Hz to 1.9kHz in 100Hz steps; 2kHz to 5kHz in 1kHz steps
Range Selection	Stand alone mode: Front panel push buttons and preset LCD buttons Remote Mode: Controlled by Huntron Workstation
Display	Color TFT LCD with Touch screen; LED back light
Pulse Generator	Level: 0 to +/- 10V DC or Square wave; Pulse mode width: 2% to 50% duty cycle; Source Resistance: 100Ω; Maximum current: 100mA per channel
Rear Panel Connections	BNC connectors for A/B Test channels and Common (used to interface to Access Prober); AUX connector for Footswitch accessory (included)
Safety	ETL (UL,CSA); CE

Huntron ® Tracker ® 3200S

Features

Specifications

Other Product

Huntron® Tracker® 2800

Huntron ® Tracker ® 2800S

Huntron® Access 2 Prober

Huntron® Access RF

Customer Service